Sparkfun to Unsped Shield Wiring Diagram

Build Process,diagrams — JP @ October 27, 2008

Sparkfun to Unsped Breakoff

Hopefully this will be of help to someone.

5 Comments »

  1. Hey – this would have been great to find out a few days ago!! :) I wired mine up and ended up having the same problems as you – mirrored nerdscroll. I mightn’t know what I’m on about here but it’s a bit of a shame the sheild couldn’t be mirrored because it could have made a really neat cable connection (I’ll blog about how I started in a while and show ya).

    I’m at the same stage as you now (needing an enclosure) – it was a lot of fun so far.

    Can you get mlr working by the way?

    Comment by jellyedwards — October 29, 2008 @ 1:49 pm

  2. For the breakoff board, is that face up (as if it were still attached to the shield) or face down?

    Comment by Ned — October 30, 2008 @ 4:36 pm

  3. Right, yeah, that’s a good question. It actually doesn’t matter. It’s the same on both side.

    What is important is the idc headers are pointing up towards you.

    Comment by JP — October 30, 2008 @ 4:40 pm

  4. I’ll take a photo later tonight of mine and have that as a comparison.

    Comment by JP — October 30, 2008 @ 4:40 pm

  5. Awesome! Man… if only I wasn’t deep into another electronics project right now, I’d totally put this picture to good use. This is just what I needed.

    This needs to go up on the Bricktable page.

    Thanks JP!

    Comment by utoks — November 7, 2008 @ 1:31 am

RSS feed for comments on this post. TrackBack URI

Leave a comment

This work is licensed under a Creative Commons Attribution-Noncommercial-Share Alike 3.0 Unported License.
(c) 2012 Nomeist | powered by WordPress with Barecity